TA
2D
|2
CHANNEL
POWER
AMP
TA
2D
|OPERATING
INSTRUCTIONS
6
|
P a g e
OPERATION
KS
AUDIO
recommends
using
KS
AUDIO
SYSTEM
‐
AMPS
with
KS
AUDIO
SYSTEM
‐
LOUDSPEAKERS
only!
If
not,
it
may
damage
parts
of
equipment.
AUDIO CONNECTORS – LINE IN/OUT
All line/audio input and output connections are a balanced electronic type
conforming to the XLR international standard, nominal 20 kOhm for matching
to a typical 50 ohm impedance line output (grounding is on pin #1). For very
long cable run installations, a transformer-balanced output is preferable to
avoid ground differentials and 50 Hz hum loops over mixed type cable runs.
The impedance is 2 x 10kOhm and is discreet (independent for pin 2 and 3).
Multiple devices can share the same input signal by using the male-female
sockets as a daisy chained audio link. A total of only 1 dB of signal loss on the
input signal is seen when up to 20 devices are sharing the same input signal.
Digital AES/EBU lines should be run with 110 Ohm cable impedance. You can
daisy chain as many products you wish, as the XLR male outputs feature an active line transmitter.
KS AUDIO recommends employing "balanced input connections”.
