Français
11
Français
11
DESCRIPTION
A
Locking lever
B
Safety button
C
Lid
D
Permanent filter
E
Glass carafe
F
Water tank lid
G
Water tank
H
Power switch
I
Cord housing
J
Gasket
K
Spoon
L
Seal of the water tank (Gasket)
BEFORE FIRST USE
n
To remove the glass carafe (E), press the safety button (B), while holding it down, simultaneously lift
the locking lever (A) .
Fig. 1
n
Remove all packaging or other accessories inside as well as outside of the appliance .
n
Run your coffee maker two times without coffee and the equivalent of a carafe of water to rinse it
(maximum 1 liter / 33 oz .) . Wait for about 5 minutes between the two cycles .
PREPARATION OF COFFEE
n
Remove the glass carafe (E) by pressing the safety button (B) . While holding it down, simultaneously
lift the locking lever (A) .
Fig. 1
n
Remove the lid (F) of the water tank .
Fig. 2
n
Fill the water tank (G) with the required amount of water .
Fig. 3
n
Use the glass carafe (E) which is calibrated in order to help you measure the quantity of water required
according to the number of cups .
Do not put the water tank directly under the tap to fill it
.
n
For more convenience, your KRUPS machine comes with a permanent filter (D) . Place this permanent
filter (D) on the glass carafe (E) .
n
Put the necessary quantity of coffee in the permanent filter (D) using the spoon provided (K) .
Fig. 4
n
For a regular coffee, we recommend 8 spoons of ground coffee for a full carafe . (1 spoon per cup)
n
Spread the ground coffee in the permanent filter (D) and flatten it slightly .
n
Place the lid (F) on the water tank (G) by positioning the handle backwards .
Fig. 5
n
The lid of the water tank (F) must be properly fixed, so that the edge of the lid surrounds the ring of rubber .
n
Place the lid (C) on the permanent filter (D) and put this unit back on the glass carafe (E) .
n
The handles of the lid (C), of the permanent filter (D) and the glass carafe (E) must be all aligned to lock
into place .
Fig. 6
n
Set up the glass carafe (E) until it stops at the front .
n
Then put the locking lever (A) back in place . The glass carafe (E) should be locked in place at that point .
Fig. 7
n
The glass carafe (E) must be positioned so that the handle is exactly in the center of the appliance and
not turned to the side .
Fig. 8 and 9
n
Please
DO NOT
open the locking lever (A) during a brewing .
n
Plug the appliance and turn it on .
Fig. 10
n
If the appliance was accidentally turned on without water, the color of the boiler may be faded . This has
no influence on the functioning of the appliance .
NB :
Please note it is normal that some time passes between the beginning of the brewing cycle and the
moment when coffee starts dripping in the carafe . This corresponds to the amount of time necessary
to increase the pressure inside the appliance . There will also be a small loss of water quantity between
what was poured initially and what is in the carafe after a brewing cycle .
n
The pressure inside the appliance is constantly renewed and the coffee will flow little by little .
n
The brewing cycle is over when the coffee no longer drips for about ten seconds .
English
Français
