Special equipment
78
Pos: 92.6 /Überschriften/Überschriften 3/A-E/A/Anbau @ 59\mod_1297664191618_78.docx @ 558472 @ 3 @ 1
18.3.2 Mounting
Pos: 92.7 /Beipacks/Mäher/EasyCut/Hydraulische Federentlastung/Gefahr Anbau Hydra. Federentlastung @ 59\mod_1297664894319_78.docx @ 558498 @ @ 1
Danger
! -
Unexpected movement of the machine
Effect: Danger to life, serious injuries
•
There must be nobody between the tractor and machine.
•
There must be nobody within the swivel range while the machine is being swivelled from
the transport into the working position or vice versa.
•
When leaving the driver's seat, switch off the engine, remove the ignition key, and secure
the tractor against rolling away.
•
Wait until all machine parts have come to a complete stop.
•
When working under or on the raised machine, support the machine securely.
Pos: 92.8 /WHB/Warnhinweise - Allgemeingültig/WARNUNG - Arbeiten an der Hydraulikanlage nur an drucklosem System @ 9\mod_1219670559536_78.docx @ 120959 @ @ 1
WARNING!
Before working on the hydraulic system, depressurise it.
Pos: 92.9 /Beipacks/Mäher/EasyCut/Hydraulische Federentlastung/GEFAHR! – Einstellung an den Entlastungsfedern @ 59\mod_1297665929816_78.docx @ 558525 @ @ 1
DANGER! – Setting on the compensation springs
Effect: Danger to life or serious injuries
•
Set the compensation springs only when the tension has been released (adjusting lever (a)
must be unlocked)
•
Compensation springs may be released only in the transport position or headland position
by moving the adjusting lever. In the working position the compensation springs are subject
to high tensile stress when the adjusting lever is locked.
•
Severe injury can be caused if the compensation springs are removed while in the working
position.
•
The lower threaded blocks on the compensation springs must be fully screwed in.
Pos: 92.10 /Beipacks/Mäher/EasyCut/Hydraulische Federentlastung/mit CV/Demontage der Entlastungsfedern @ 60\mod_1297689260274_78.docx @ 560013 @ @ 1
The compensation springs are removed and installed always in the working position.
EC-374-0
a
Fig. 48
•
Bring the machine into the transport position
•
Unlock adjusting lever (a) as illustrated
•
Move the machine to the working position
Pos: 92.11 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
Summary of Contents for EasyCut R 360
Page 85: ......
