Setup pages
NDX can be con
fi
gured from the SETUP page on the management website. The SETUP
page has the following sub-pages:
NETWORK SETUP
The device has
fi
ve physical ethernet interfaces: a management 1 Gb interface (eth0)
and four SFP+ interfaces (eth1 to eth4). Only the SFP+ interfaces support L2TP
streaming and IEEE-1588 synchronization. The SFP+ interfaces does not support DHCP
and must be con
fi
gured with a static IPv4 or IPv6 address. The management interface
supports both static and DHCP. Each interface can only operate in either IPv4 or IPv6
mode, but not both.
Changes on this page is applied immediately without needing reboot.
Management interface (eth0)
•
DHCP
◦
Activate DHCP. If checked the interface will use DHCP to obtain its IP
con
fi
guration. Only IPv4 is supported with DHCP.
◦
Type: On / O
ff
•
IPv4 Addr./Netmask
◦
Enter IPv4 address/mask for the interface. Ignored if DHCP is enabled.
◦
Type: String
•
IPv4 Gateway
◦
Gateway for the interface. Enter an IPv4 address to use as gateway, or leave
blank for no gateway. Ignored if DHCP is enabled.
◦
Type: String
•
IPv6 Addr./Netmask
◦
Enter IPv6 address/mask for the interface. Ignored if DHCP is enabled.
◦
Type: String
•
IPv6 Gateway
◦
Gateway for the interface. Enter an IPv6 address to use as gateway, or leave
blank for no gateway. Ignored if DHCP is enabled.
◦
Type: String
www.kronback.com | [email protected]
NDX Manual - Setup pages
16 of 24