EN
page 37
N.B.: For any other question, please contact your Service provider.
The manufacturer has right to modify any technical characteristics without prior notice.
Type of Problem
Possible Causes
Cure
Wash time insuf
fi
cient for the type
of dirt.
Select a longer wash-cycle, if possible, otherwise repeat
the wash cycle.
Wash water is dirty.
Drain the tank water, clean the
fi
lters; re
fi
ll the tank and
replace the
fi
lters correctly.
Glasses or dishes are not
properly dried.
Not enough rinse aid.
Increase dosage by turning the dispenser screw (call for
Service).
The rack is not suitable for the
pots or the tools.
Use the suitable rack which gives the pots and tools an
inclined position so that water can rinse away.
The washed items may have
been sitting in the wash chamber
too long.
As soon as the cycle stops, remove the rack with pots
and tools so that they can dry more quickly in the air.
Rinse temperature under 80°C.
Check the boiler thermostat temperature.
Surface of dishes and glasses too
rough or porous for material wear.
Replace type of dishes and glasses used. If the dirt on
the dishes is dry and old, soak before washing.
Streaks and spots on
glasses and dishes.
Too much rinse-aid chemical.
Reduce the rinse aid amount by turning the micrometric
dispenser screw (see par. 1.4 "Rinse aid dispenser").
Too hard water.
Check the water quality. Water must not exceed 8°f in
hardness.
For appliances with softener: too
little salt in the salt container or
the resins have not been properly
regenerated.
Fill the salt container (coarse salt: 1-2 mm grains) and
regenerate the resins more often. If lime deposits are also
observed on the body of the machine, have a quali
fi
ed
technician check the operation of the water softener.
Salt present in dishwasher sump. Thoroughly clean and rinse the appliance, and avoid spil-
ling salt when
fi
lling the container.
The machine suddenly
stops during operation.
The machine is connected to an
overload device.
Connect the machine on a own overload device (call for
Service).
A machine safety device was
triggered.
Check the electrical devices (call for Service).
The machine stops
during the wash stage
and starts re
fi
lling water.
The previous day's water was not
changed.
Drain the tank totally and re
fi
ll.
Excessive water temperature in
tank.
Call for Service to check thermostat and pressure-switch.
Defective pressure switch.
