EN
page 30
WARNINGS:
• Do not slam the door when opening and closing.
• Do not put material or objects on the machine.
• The machine has an IPX3 protection rating against accidental water splashes and is not
protected against pressurized water jets. Pressure-cleaning systems shall, therefore, not
be used on this machine.
• Do not dip bare hands into water containing detergent. If this should occur, wash
them immediately with plenty of water. Check the safety instructions on the detergent
container.
• Some important rules must be followed for using this appliance:
1) never touch the appliance with wet hands or feet;
2) never use the appliance when barefooted;
3) do not install the appliance in places exposed to water splashes.
• This machine must be disconnected from the main electrical supply after use at
the end of the day and for any service/maintenance operation. Switch off the main
switch located on the wall, which shall be installed by a professional installer. Shut
the water supply valve(s).
• Do not cover the intake or dissipation grids.
•
.
WARNING: INTERNAL CLEANING OF THE MACHINE SHALL BE CARRIED OUT AT
LEAST 10 MINUTES AFTER THE POWER SWITCH HAS BEEN TURNED OFF.
WARNING: DO NOT INSERT HANDS AND/OR TOUCH THE PARTS LOCATED AT THE
BOTTOM OF THE WASH TANK AND/OR AT THE END OF THE WASH CYCLE.
3. ECOLOGICAL ASPECTS
3.1
Recommendations for optimal use of energy, water and additives
Salt dosing
A pre-set (by the manufacturer) quantity of salt is injected in the resins at each regeneration
cycle. It is important to observe the number of regeneration cycles recommended in para-
graph
2.6 Regeneration device
in order to avoid salt spills or lime deposits.
Use the machine fully loaded when possible.
This shall prevent detergent, rinse aid, water and energy consumption waste.
Detergent and rinse-aids
Use detergents and rinse-aid chemicals with high biodegradability, to best respect the en-
vironment. Verify proper dosage in relation to water hardness at least three times a year.
Excess product pollutes rivers and seas while an insuf
fi
cient dose results in unsatisfactory
dish washing and/or hygiene.
Boiler and Wash-Tank temperatures
The boiler and tank temperatures are set by the manufacturer in order to obtain the best
washing results with detergents on the market. The temperatures can be reset by the installer
in relation to your detergent.
Pre-washing
Carefully pre-wash with a moderate amount of water at room temperature to facilitate the
removal of animal fats. To remove encrusted materials warm water soaking is recommended.
Note:
Wash objects as soon as possible to avoid deposits from drying and compromise effective
washing.
For effective washing routine dishwasher cleaning and maintenance is advised (see chap.
5
).
Disregarding the points listed above and of any the information contained in this
manual can cause energy, water and detergent waste with a subsequent increase in
running costs and/or performance reduction.
