EN
page 29
IMPORTANT:
Before starting a regeneration cycle check if there is salt in the special container (max
0,500kg).
Fill the special salt container with tank empty and machine off.
When displaying
"NO SA"
(alternated to the tank and boiler temperatures and with machi-
ne on stand-by mode) add salt in the container in the wash-tank (only with optional water
softener).
Rinse the tank immediately if salt is spilled in it.
To start the regeneration cycle, switch the machine off with the key
"J"
.
The red LED lights up.
Empty the tank. Remove the over
fl
ow.
For machines equipped with drain pump see par.
2.5
.
Press the
"K"
button; the display will show
"rege"
.
The regeneration LED lights up and the machine carries out with the various phases.
The cycle is
fi
nished when the indicator
"F"
goes off, after around 20 minutes.
Note:
Regeneration times will be blocked only if the door is opened.
The optional regeneration is not allowed in the following conditions:
• during programming.
• during the wash cycle.
• during manual draining.
• if the door is open; in this case the message
"DOOR"
will be displayed for about 4sec.
• if the machine is ON.
2.7
Additional Cooling Function (Optional)
This function can only be enabled if the machine is installed with the optional
"Additional
Cooling"
function.
Machine ON. Press the button
"K"
for at least 3 sec.
After the hot rinse is completed, an additional fresh-water rinse can be made.
During the wash cycle or manual draining the type of rinse selected cannot be changed.
The Additional Cooling selection is displayed with the decimal
point of the second display lighting up.
Note: The Additional Cooling selection is not memorised and
must be set every time the machine is switched off and then
on again (if this function is required).
