KROHNE OPTISWITCH 5200C, Handbook

Page: 8 / 16

8
5 Setup
Electronics module • OPTISWITCH 5100 C, 5150 C, 5200 C, 5250 C
30492-EN-210907
5 Setup
5.1 Setup
When replacing the electronics module, make sure that all adjustment
elements are set to the settings of the old electronics module. Hence
the sensor is immediately ready for operation.
In general, the electronics module can be also exchanged within the
type series against an electronics with another signal output (e.g.
relay against transistor output). The electronics modules of the high
temperature version, however, cannot be exchanged against standard
instrument versions.
If you want to use an electronics module with a completely different
signal output, you have to carry out the complete setup.
The necessary, suitable operating instructions manual can be down-
loaded from our homepage under Downloads.
The adjustment should be carried out according to the description in
the operating instructions manual.
Note:
Keep in mind that enamelled instrument versions require special
electronics modules.
Setup