KROHNE MFC 400, Supplementary Instructions Manual

Page: 4 / 32

1
INTRODUCTION
4
MFC 400
www.krohne.com 12/2017 - 4006097501 - AD MFC 400 Profinet R01 en
1.1 Scope of the document
These instructions are supplementary to the standard handbook of the MFC 400 with ER 2.0.x
(refer to document MA MFC 400 from version R05). They provide additional information for the
devices when being operated and connected to a PROFINET IO network.
To ensure safety, please read this document carefully before installation and follow the
instructions herein.
1.2 Used abbreviations
AWG American Wire Gauge
DAP Device Access Point
DCP Dynamic Configuration Protocol
EIA/TIA Electronic Industries Alliance/Telecommunications Industry Association
EMC Electromagnetic Compatibility
EMI Electromagnetic Interference
GSD General Station Description
GSDML General Station Description Markup Language
ID unique Parameter ID
I&M Information & Maintenance
I/O Input/Output
IEC International Electrotechnical Commission
IEEE Institute of Electrical and Electronics Engineers
IP Internet Protocol
IRT Isochronous Real-Time
LFC Low Flow Cut-off
LLDP Link Layer Discovery Protocol
MAC Media Access Control
MIB Management Information Base
NIC Network Interface Controller
OUI Organizationally Unique Identifier
PE Protective Earth
PLC Programmable Logic Controller
PN PROFINET
PNIO PROFINET IO
RT Real-Time
SNMP Simple Network Management Protocol
t63 Time until 63% of the end value is reached for a step change.
For details refer to Locking of configuration on page 16, ID 61.
Table 1-1: Used abbreviations