Supplementary Documentation
Page 17 of 44
IFC090, IFC090 i with FF
IFC090-FF Block Description
IFC090 FF 01/2005
KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5
D-47058 Duisburg
Tel.: 0203-301 309
Fax: 0203-301389 · E-mail: [email protected]
Parameter
Access
Description
ßALARM_SUM R
Display of process alarms. The current alarm is displayed in the
current
field
an can have the following values:
Discrete Alarm
the soft write lock was cleared
HiHi Alarm
the high limit alarm is active
Hi Alarm
the high limit advance alarm is active
Lo Alarm
the low limit advance alarm is active
LoLo Alarm
the low limit alarm is active
Block Alarm
block mode switches to Out of Service
The additional fields
unacknowledged
and
unreported
give respective
information about the current alarm state. The field
disabled
, which is the
only writable field of this parameter, can be used to disable these alarms.
see also:
ACK_OPTION
ALERT_KEY R/W
ALERT_KEY parameter contains the identification number of the plant unit. It
helps to identify the location (plant unit) of an event. The handling of this
parameter is up to the control system or control person, respectively.
BLOCK_ALM R
Display of current block state. Field
subcode
gives information about the
state current errors. The following errors can occur:
Configuration Error
Block was put Out of Service
The remaining fields give information about the state and the occurrence of
this alarm.
BLOCK_ERR R
Display of active block errors. The following errors are possible:
Out of Service
block is in
Out of Service
mode
Input
Failure
SIMULATE.status
is
Bad:NonSpecific
Simulate
Active
SIMULATE.enable
= yes
Block Configuration Error
channel unit !=
XD_SCALE.unit
, or
CHANNEL
!= 1, or
L_TYPE
is uninitalized
CHANNEL R/W
Number of the transducer’s logical hardware channel that is connected to
this Analog Input block. The only valid value is ‘1’ (since the Transducer has
only one hardware channel). Every other value would cause an ‘Block
Configuration Error’ which is displayed in BLOCK_ERR.
The default value is ‘0’.
FIELD_VAL R
Raw value of the field device in percent of the
PV
range, with a status
reflecting the Transducer condition, before characterization (
L_TYPE
) or
filtering (
PV_FTIME
). See 5.3.3 for details.
GRANT_DENY R/W
Options for controlling access of host computer and local control panels to
operating, tuning and alarm parameters of the block.
NOTE:
This parameter is not supported by IFC090-FF.
HI_ALM R
With subject to the setting of
HI_PRI
, HI_ALM shows details about the high
alarm as acknowledge state and time stamp. See
HI_PRI
for details.
see also:
HI_PRI, HI_LIM
HI_HI_ALM R
With subject to the setting of
HI_HI_PRI
,
HI_HI_ALM
shows details about the
high high alarm as acknowledge state and time stamp. See HI_HI_PRI for
details.
see also:
HI_HI_PRI, HI_HI_LIM
HI_HI_LIM R/W
The limit value in engineering units as of the
HI_HI_ALM
is active (with
subject to
HI_HI_PRI
).
see also:
HI_HI_PRI, HI_HI_LAM
