Krautzberger MP-520, Operating Instructions Manual

Page: 29 / 53

CAUTION!
Risk of injury due to sharp edges!
Sharp edges and pointed corners can cause abrasions and cuts on the skin.
Note:
– Proceed cautiously when working on or near sharp edges and pointed corners.
– Wear protective gloves, if in doubt.
Hose and pipelines
Even with intended use by environmental influences, the service life of hose lines and pipe-
lines is limited. For the sake of prevention, all hose and pipelines should be replaced regularly
according to their load.
7.2 General maintenance information
The following sections describe the maintenance work that is required for optimal and fault-free
operation of the device.
Check wearing parts such as seals at regular intervals. The level of wear depends on the abrasive-
ness of the spray fluid used. Escaping air and spray fluid are signs that parts are worn. In case of
questions about maintenance work and intervals, contact the manufacturer; see contact informa-
tion on the last page.
7.3 Maintenance schedule
Interval Maintenance work
Prior to each work process Check the material or compressed air lines to make sure they
are undamaged and have a secure fit
Before performing any mainte-
nance work Clean diaphragm pump ( Ä Chapter 7.4 ‘Clean the diaphragm
pump’ on page 30 )
Prior to every long-term shut-
down
When necessary Clean diaphragm pump (
Ä
Chapter 7.4 ‘Clean the diaphragm
pump’ on page 30 )
Replace valve parts (
Ä
Chapter 7.5 ‘Replace valve parts’
on page 31 )
Replace diaphragms ( Ä Chapter 7.6 ‘Replace the diaphragm’
on page 33 )
Diaphragm pump MP-520
ENGLISH
Article No. 200-0216, 200-0330 GB–29