15
KRAUSMANN POWER TOOLS
9005
12
14
13
English |
EN
SAVE THESE INSTRUCTIONS
4. Functional description
and specifications
WARNING:
M
isuse or failure to follow the safety rules stated in this
instruction manual may cause serious personal injury.
WARNING:
I
f the replacement of the supply cord is necessary, it has
to be done by a professional to avoid a safety hazard.
Intended use
The sander is intended for sanding various
surfaces and material.
Power supply
Power input
No load speed
Backing pad size
Weight
230V~50Hz
260W
13000/min-1
90 × 187 mm
1.80kg
Tool
9005
Do not point the tool at any one in the area
when operating. Parts could fly out and injure
somenone seriously.
Do not touch parts close to the bit immedi-
ately after operation; they may be extremely
hot and could burn your skin.
Some material contains chemicals which
may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
sandpaper or the dust collector.
K
eep the extension cable away from the
work area. Position the extension cable so
that it cannot become entangled in the work-
piece, sander or other obstacle when working
with the sander.
I
f an extension cable is to be used, it must be
in good condition. In addition, also ensure
that the extension cable has an sufficiently
large capacity (cable area) for the current
used by the sander. Extension cables with
an inadequate cable area deliver insufficient
voltage, which leads to lower outputand
overheating.
M
ake sure the extension cable is correctly
connected and is in good condition. Replace
damaged extension cables or get an electri-
cian to repair them prior to use. Protect ex-
tension cables from sharp objects, excessive
heat, steam and damp areas.
Additional safety regulations for
sanders
Always use protective goggles that conform
to the requirements of applicable safety
standards. When using power tools, there
is always a danger of foreign objects flying
off and hitting the eyes of the user or those
standing close by and causing permanent
injury.
Always use a dust mask when sanding.
Always use ear defenders when sanding,
particularly if you are going to work for long
periods without interruption.
Always disconnect the sander from the mains
before changing the sanding pad and prior
to cleaning.
Do not wear ties or loose clothing.
Secure the workpiece. Use a vice or clamps
to secure the workpiece if appropriate. This
is safer than holding it with your hand and
allows you to operate the sander with both
hands.
A workpiece that is too small to be secured
safely must not be sanded using the ma-
chine.
Always check that the area to be sanded does
not contain nails or other foreign objects.
K
eep your hands away from the sanding pad.
Avoid placing your hands where there is a
chance that they may come into the path of
the sanding pad should the sander suddenly
jerk or slide uncontrollably.
Avoid damage caused by accidental starts
by always disconnecting the plug from the
mains socker before fitting or removing
