18
9005
KRAUSMANN POWER TOOLS
B
C
A
A.
Locking tabs
B.
Dust box (upper)
C.
Dust box (bottom)
English |
EN
5. Maintenance
For safe and proper working, always keep the
tool and ventilation slots clean.
Τhe tool may be cleaned most effectively with com-
pressed dry air.
Always wear safety goggles when
cleaning tools with compressed air.
C
ertain cleaning agents and solvents dam-
age plastic parts.
Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
T
he brushes and commutator in your tool have
been engineered for many hours of dependable
service. To maintain peak efficiency of the motor, we
Wear ear defenders
Wear safety goggles
Wear a dust mask
This tool has been checked by the manufacturer.
From the date of purchase by the final consumer,
a two year warranty for
amateur use
covers any
faulty material and manufacturing. The receipt or
invoice of purchase needs to be displayed in case
of a repair that is covered by the warranty. For
possible faults during the warranty period, you
should address your issue to the retail shop from
which the purchase was made.
6. Warranty
Terms of warranty
The tool has been used properly and for the
purpose for which it was purchased.
T
he tool presents a problem that is due to
faulty material and manufacturing.
I
ncapability of the tool to perform according
to the technical specs provided.
Damages are not covered by the warranty that are
due to causes such as:
W
ear due to improper use.
Partial or total disassembly.The tool’s shell
must be disassembled only by personnel
authorised by the official distributor.
Damage due to overloading.
Usage of incorrect or incompatible accessory.
Bad maintenance from the operator or any
other third party.
W
ear that was induced by external factors or
The warranty is valid only when:
NOTE:
It is best to perform this function either outside or over a
trash can, as loose dust will come out of the dust box very
easily.
NOTE:
The locking tabs
A
will “snap” into place when the dust
box is fully pushed onto the rear of the sander.
i
i
Shake all the dust out of the dust box.
Use a soft DRY brush to remove the dust
from the filter located inside the top of the
dust box.
O
nce all the sanding dust is removed form
the dust box, press the upper and lower
sections together. They will “snap” into place
when properly assembled.
R
einstall the dust box onto the rear of the
sander.
fig 6
recommend every two to six months the brushes be
examined.
Store the tool, operating instructions and where
necessary the accessories in the original packaging. In
this way you will always have all the information and
parts ready to hand.
