6
Manual
www.kraun.com
First, Connect the IP CAM to the home/office network
Please connect the IP CAM accessaries to the IP CAM body correctly, including the antenna, bracket, power
adapter and Ethernet cable, as shown in Figure 2-3. And connect the other end of the Ethernet cable to the
home network or office network. Usually, this Ethernet cable is plugged into a home NAT/router device or
an Ethernet switch if in the office, as shown in Figure 2-4. Since the default settings of the IP CAM use DHCP
function and very often there is a DHCP server on most of the Home/office network, the IP CAM should be
connected to the Internet immediately. The Internet status LED is constant red light to indicate this good
connection status. If the LED is blinking, please refer to section 3.3~3.5 to try other network settings.
Figure 2-3: IP CAM connection diagram.
Figure 2-4: Connect Ethernet cable to a switch/router.
