14
Manual
www.kraun.com
3.4. WiFi security (For IP cam
(
w
)
)
You can use the wireless to connect the IP CAM to the network. If your network environment has a 802.11
b/g router or AP running, you can check the “Enable WiFi function” button to use the wireless.
Figure 3-7: WiFi security disabled page
In order to use the wireless network, you need to fill the following fields:
1. SSID – this is the ID of the wireless router or AP of your wireless network environment, must be set
correctly.
2. Security mode – this is the security mode used in the wireless router or AP. Need to choose one of the
three modes – None, WEP and WPA-PSK.
3. WEP : Wireless Encryption Protocol.
4. WPA : WiFi Protected Access.
5. PSK : Pre-Shared Key.
6. TKIP : Temporal Key Integrity Protocol.
7. AES : Advanced Encryption Standard.
8. WEP mode – when the WEP mode is chosen, you need also choose between 64-bit(5 char), 64-bit(10
hex), 128-bit(13 char) and 128-bit(26 hex) encryption mode, and then fill the WEP key correctly.
9. WPA-PSK mode - when the WPA-PSK mode is chosen, you need also choose between TKIP and AES
encryption mode, and then fill the WPA-PSK key correctly. WPA2-PSK is also supported. But WPA
Enterprise or WPA2 Enterprise is not supported.
