7
this duration may increase or decrease depending on how it is used and/or the results of annual checks.
The equipment should be inspected if there is any doubt, or following a fall, and at least annually, by the manufacturer or a competent person and in
strict compliance with the manufacturer’s periodic inspection procedures (and in particular the inspection guides ref. GI XX-XXXXXX-XX) to check
its strength and therefore the user’s safety. The “Equipment identification sheet” should be completed (by writing) after each verification; date of
inspection and date of next inspection must be indicated on the “Equipment identification sheet”, it is also recommended to put date of next inspection
on the product.
SERVICING AND STORAGE:
(Comply strictly with these instructions)
During transport, keep the harness in its packaging, well away from any cutting surface. Clean it with water and soap, wipe it with a dry rag and
hang it up in a well-ventilated location, to let it dry naturally and away from a naked flame or heat source; follow the same procedure for components
that have become damp during use. The metal parts should be wiped with a cloth impregnated with paraffin oil. Never use bleach or detergents. The
harness should be stored in its packaging in a warm, dry, ventilated place, protected from sunlight, heat and chemicals.
Summary of Contents for FA 10 500 00
Page 8: ...8 NOTES ...
