Krampouz CEBPF2, Instructions For Use Manual, Page: 15 / 32

- 15
-
towards you in the groove of the hot plate
3. Pour the whole ladle of batter into the spreader in one go without trying to spread it out
inside it and immediately turn it clockwise. The first turn must be made in 2/3 seconds.
Continue to rotate gently until the remaining batter in the spreader is spread out then put it
back in the tray of water. You can also spread out this remaining batter with the wooden
rake.
4. Leave the crepe to cook for approximately 10 to 15 seconds before turning it over. To do
this, slide the crepe turner gently under the edge of the crepe, turn your wrist and lift up the
crepe confidently, then turn it over onto the other side.
For crepes to be eaten cold, cook the other side only slightly.
For crepes to the filled, follow the instructions in the recipe book.
Between each pancake, clean the baking residue plate, without adding oil.
Clean the spreader with the brush and put it back in the water.
Tips
Always spread out the batter in a clockwise direction, never going backwards.
If required, apply gentle pressure to the spreader on the hot plate when rotating it.
Always make sure the batter has no lumps, sieve it if required.
To reheat crepes, use thermostat positions under 3.
Certain ready-made batters are not designed to be spread out with the spreader.
To ensure the coating of the hot plate has a long life expectancy, do not overgrease it and only use
wooden or plastic accessories.
You are advised to keep the original packaging to store the appliance and its accessories.
Maintenance and Cleaning
-
The non-stick hot plate does not require any specific maintenance. Simply wipe the crepe
maker with a soft sponge slightly humid and soaked with a bit of washing-up liquid.
-
Avoid using chemical cleaning products and abrasive sponges on the non-stick hot plate.
-
The frame and base can be cleaned with a damp sponge.
-
Attention: Never wash this appliance in a lot of water. Disconnect it prior to cleaning it.
-
If you have to replace the power supply cord, replace it with a cord of the same type H05RRF-
3X0.75
2
, fitted with a plug suitable for "hot conditions", the hot plate socket end.