KRAMER: SIMPLE CREATIVE TECHNOLOGY
Defining the VS-88DTP 8x8 DVI - Twisted Pair Matrix Switcher
6
Figure 2
and
Table 2
define the front view of the
VS-88DTP
.
Figure 2: VS-88DTP 8x8 DVI - Twisted Pair Matrix Switcher Rear View
Table 2: VS-88DTP 8x8 DVI - Twisted Pair Matrix Switcher Rear Panel Features
#
Feature
Function
1
IN 1
to
IN 8
DVI Input Connectors
Connect to the DVI sources
2
OUT 1
to
OUT 8
RJ-45 TP Output Connectors Connect to the TP receivers (for example, PT- and TP-574)
3
RS-232
9-pin D-sub (F)
Connect to a PC or other serial remote controller
4
PROG TERM
2-way DIP-switch
DIP-switch 1
Sets the RS-485 bus termination (see
Section 6.2.2
)
Up = Off, Down = On. Default = On
DIP-switch 2
Sets the Programming mode. Only for the use of
Kramer service personnel. Default = Off
5
RS-485
3-pin Terminal Block
Connect to a serial controller or to another VS-88DTP unit.
Connect G to Ground, B to B, and A to A (see
Section 6.2
)
6
ETHERNET
RJ-45 TP Connector
Connect to a PC or LAN for remote control
7
REMOTE IR
3.5mm Mini Jack
Connect to an external IR receiver unit for controlling the device via an IR remote controller (instead of using
the front panel IR receiver)
8
MACH #
DIP-Switch
Sets the RS-485 bus machine number (see
Section 6.2.1
)
9
RESET
Button
Press the reset button while turning the device on in order to reset the Ethernet factory default definitions
(see
Section 10
)
10
AC Power Receptacle
Connect to the AC mains power supply
11
AC Mains Fuse
AC mains supply protection fuse
12
AC Mains Power Switch
Turns the AC mains power supply to the device on and off