46
VS-1616D-MD - Using the Configuration Menus
8.2.3
Config Menu
—Output Load Detection Display
This option displays a list of outputs and indicates which have loads attached to
them.
To display a list of outputs and attached loads:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup, ENT to change them
2. Press MENU until the following is displayed:
OUT: 01 02 03 04 05 06 07 08 09 10 11
LOAD: Y X Y Y Y Y X Y Y Y X
Y indicates that a load is attached and X indicates that no load is detected
on the relevant output.
3. Do one of the following:
Press BREAKAWAY to exit the Config Menu
Wait approximately 15 seconds for the operation to time out
Press MENU to move to the next Config Menu option
8.2.4
Config Menu
—Output Port Parameter Setting
This option sets port specific parameters. Ports that show an X have no
parameters available to modify. Ports that show a 0 have parameters available to
modify. The parameters that are available, such as, audio balance, depend on the
type of card installed and whether the card is an input or an output card. Tables
listing output cards and their parameters can be found at the end of this section.
To set parameters for a port:
1. Press MENU twice.
The following message is displayed:
start configuration menu
MENU to view setup ENT to change them
