Your VP-4x8AK 4x8 VGA / UXGA / Audio Matrix Switcher
9
9
Table 3: Rear Panel VP-4x8AK 4x8 VGA / UXGA / Audio Matrix Switcher Features
#
Feature
Function
1
AUDIO INPUT
3.5mm Mini
Connectors
Connect to the unbalanced stereo audio acceptors (from 1 to 4)
2
AUDIO OUTPUT
Terminal Block
Connectors
Connect to balanced stereo audio sources (from 1 to 8)
3
Power Switch
Switch for turning the unit ON or OFF
4
INPUT
XGA
15-pin HD Connectors
Connect to the video sources (from 1 to 4)
5
LOOP
XGA
15-pin HD Connectors
Connect looped input to output acceptor (1 to 4)
6
OUTPUT XGA
15-pin HD Connectors Connect to the output acceptors (from 1 to 8)
7
PROG
Button
Push in for “Program” to upgrade to the latest Kramer firmware
via RS-232 (see
Section 8
), or release for “Normal” (the factory
default)
8
RS-485 TERM
DIP-switch
Use for RS-485 Termination
1
9
: ON for RS-485 Line Termination
with 120
Ω
; OFF for no RS-485 Line Termination
RS-232
9-pin D-sub Port
Connects to the PC or the remote controller
10
REMOTE IR
Opening
2
Connects to an external IR receiver unit for controlling the
machine via an IR remote controller instead of using the front
panel IR receiver
3
11
FACTORY RESET
Button
Press to reset to factory default definitions
4
:
IP Address:
192.168.1.39
Mask:
255.255.255.0
Gateway:
192.168.1.1
12
ETHERNET
Connector
Connects to the PC or other serial controller through computer
networking
13
RS-485
Terminal Block Port
Pins B (-) and A (+) are for RS-485; Pin G (Ground) may be
connected to the shield of the cable if desired
14 Power Connector with Fuse
AC connector enabling power supply to the unit
4.1
Using the IR Transmitter
You can use the
RC-IR3
IR transmitter to control the machine via the built-in IR
receiver on the front panel or, instead, via an optional external IR receiver
5
. The
external IR receiver can be located up to 15 meters away from the machine. This
distance can be extended to up to 60 meters when used with three extension cables
6
Before using the external IR receiver, be sure to arrange for your Kramer
dealer to insert the internal IR connection cable
24F
7
with the 3.5mm connector
that fits into the REMOTE IR opening on the rear panel. Connect the external
IR receiver to the REMOTE IR 3.5mm connector.
1 The first and the last units on the RS-485 line should be terminated (ON). Other units should be unterminated (OFF)
2 Covered by a cap. The 3.5mm connector at the end of the internal IR connection cable fits through this opening
3 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the machine (only if the internal
IR connection cable has been installed)
4 Turn the machine OFF using the power switch and then turn it ON while pressing the ETH Factory Reset button. The unit
will power up and load its memory with the factory default definitions
5 Model: C-A35M/IRR-50
6 Model: C-A35M/A35F-50
7 P/N: 505-70434010-S
