KRAMER: SIMPLE CREATIVE TECHNOLOGY
Configuring a 1:2 XGA/HD-to-Twisted Pair DA System
6
Figure 4: TP-112HD (Underside Panel)
Table 2: TP-112HD (Underside Panel) Features
#
Feature
Function
1
VS Switch
Slide the switch to the left
to change the VS polarity to NEGATIVE polarity
; slide
the switch to the right (to NORMAL) to retain the polarity
2
HS
Switch
Slide the switch to the left
to change the HS polarity to NEGATIVE polarity
; slide
the switch to the right (to NORMAL) to retain the polarity
5
Configuring a 1:2 XGA/HD-to-Twisted Pair DA System
You can use the
TP-112HD
XGA/HD Line Transmitter – DA
with two
TP-120
XGA Line Receiver
units
to configure a 1:2
XGA/HD
-to-Twisted
Pair DA system. This will let you transmit a computer graphics/HD signal to
two displays via long line CAT 5 UTP cabling.
To
connect the
TP-112HD
to two
TP-120
illustrates, do the following:
1. On
the
TP-112HD
, connect the XGA/HD source (for example, a
computer graphics/HD source) to the XGA/HD INPUT 15-pin HD
connector, and connect the line output RJ-45 connector
:
OUT 1 connector to the LINE IN RJ-45 connector on the first
TP-120
OUT 2 connector to the LINE IN RJ-45 connector on the second
TP-120
1 By default, both switches are set to the right
2 Downgoing syncs
3 Refer to the separate user manual: PT-110, PT-120, TP-120, WP-110, which can be downloaded from the Internet at:
http://www.kramerelectronics.com
4 Via UTP cabling (with a range of more than 300ft (>100m)). For details of how to wire a CAT 5 LINE IN/LINE OUT
RJ-45 connector, see section
5.1