![background image](http://html1.mh-extra.com/html/security-brands/14-r300/14-r300_instructions_1232010001.webp)
ON
1
2
3
4
5
6
7
8
9
10
INSTRUCTIONS
Model
14-R300
1 of 2
IN THE BOX
Make sure you have everything shown here.
NOTE: The CR2032 battery comes pre-installed.
Visor Clip
Button 1
LED
Button 2
DIP Switches on Receiver 300
(default positions)
WHAT’S WHAT
The 300-MHz Transmitter has two programmable buttons and
a status LED. Each button can be paired to a separate
receiver or the same receiver.
SETUP
1. On your 300-MHz receiver, set DIP switches to
desired positions.
NOTE: For best results, we recommend using
the Security Brands Receiver 300 (14-REC300).
NOTE: By default, both sets of DIP switches on
switch positions of the Receiver 300 and other
300-MHz receivers. For security reasons, we
recommend using custom DIP switch positions.
NOTE: Some DIP switches may be labeled
to the position labeled 0 on the remote, and
position labeled as OPEN.
2. Open 300-MHz Transmitter unit by removing two screws
on bottom side and pulling case apart. Remove
visor clip if needed for easier access.
NOTE: Make sure the circuit board stays
attached to the base of the remote unit and
300-MHz Transmitter
300-MHz Transmitter
the 300-MHz Transmitter are matched to the default DIP