Using the SG-6006
KRAMER: SIMPLE CREATIVE TECHNOLOGY
8
2. Connect the SDI OUTPUT BNC connectors to up to four SDI acceptors
2
(for
example, OUTPUT 1 to a non-linear editor).
3. Connect the AUDIO OUTPUTS as follows:
The LEFT and RIGHT ANALOG RCA connectors to an analog stereo
audio acceptor (for example, the audio input on the Kramer
VS-808xl
8x8
Video / Audio Matrix Switcher
)
The AES 75
Ω
BNC connectors (for channels 1+2 and 3+4) to AES 75
Ω
(AES-3id) digital stereo audio acceptors
1
The AES/EBU XLR connectors (for channels 1+2 and 3+4) to AES/EBU
digital audio acceptors
1
The LEFT and RIGHT BALANCED ANALOG XLR connectors to an
analog balanced stereo audio acceptor
1
4. If required
1
A Genlock source to the REFERENCE INPUT BNC connector
, connect:
2
The LOOP
BNC connector to the INPUT BNC connector of the next unit
in the line, and release the TERM
button for looping
3
5. If required, connect a PC and/or controller to the RS-232 port (see
Section 7
6. Connect the power connector to the mains electricity
).
1
.
7
Using the SG-6006
This section describes how to:
•
Operate the
SG-6006
(see
Section 7.1
•
Use front PANEL LOCK button (see
)
Section 7.2
7.1 Operating the SG-6006
)
The
SG-6006
can save and load up to 16 setups via the menu.
To use the menu, press the:
•
MENU button to start or exit the menu
•
ENTER to enter a submenu, load a setup, accept changes and reset to the
default settings
•
and
buttons to scroll through the menu and sub-menus
•
and
to increase or decrease numerical values or select from several
definitions of a setup
Upon exiting the menu, the SAVE SETTING AS item appears.
Table 2
defines the menu items.
1 Not illustrated in Figure 2
2 Press the GENLOCK button to toggle between a genlocked generator and a free-running generator
3 Pushed in terminates the input. Release when the input extends to another unit
