![background image](http://html1.mh-extra.com/html/kramer/mv-6/mv-6_user-manual_2001600016.webp)
12
MV-6 - Connecting the MV-6
5.2
Connecting via Ethernet
You can connect to the
MV-6
via Ethernet using either of the following
methods:
Directly to the PC using a crossover cable (see
Section
Via a network hub, switch, or router, using a straight-through cable (see
Section
Note
: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
5.2.1
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
MV-6
directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
MV-6
with the factory configured default IP address.
After connecting the
MV-6
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device
and click
Change settings of this connection
.
The Local Area Connection Properties window for the selected network
adapter appears as shown in
i
Summary of Contents for MV-6
