KW-14T-IL/KW-14R-IL - Connecting the KW-14T-IL and KW-14R-IL
11
5.2
Registering a Transmitter and Receiver
A transmitter can be registered with either one or multiple, (up to four) receivers. A
receiver can be associated with up to three transmitters. Registration of one or
more receivers to a transmitter is performed using either the buttons on the devices
or the remote IR control in conjunction with the OSD. Registration of more than one
transmitter to a receiver can only be done using the IR remote control and the OSD.
When purchased as a pair, the
KW-14T-IL
and the
KW-14R-IL
are delivered
pre-registered. Registration needs to be performed only when:
•
The transmitter or receiver is replaced
—OR—
•
Adding additional receivers to a transmitter or additional transmitters to a
receiver
Note
: Registration is not lost when the devices are powered off.
When registering multiple receivers separate them by at least 2m (6.5ft). When
employing multiple transmitters at the same site, separate them by at least 2m
(6.5ft).
Note
: The video link must be off when registering additional transmitters.
5.2.1
Registering by Using the Buttons on the Devices
To register a transmitter with a receiver by using the panel buttons
:
1. Connect and apply power to the transmitter, input source, receiver, and
output acceptor.
2. Press and hold the Register button on the receiver until the following
message is displayed on the OSD:
“Please activate registration on Transmitter unit”.
3. Press and hold the Register button on the transmitter until the following
message is displayed on the OSD:
“Adding <
transmitter name>
. Press OK to continue
or EXIT to cancel”.