FC-340S - Connecting the FC-340S
7
7
4. Connect the CV ANALOG OUTPUT BNC connector to a composite video
acceptor (for example, a composite video recorder). See the Note in
Section 6.1
.
5. Connect the 5-pin terminal block to a balanced audio acceptor (for example,
an amplifier).
6. Connect AES digital audio sources (for example, DAT players) to the
AES/EBU IN 1 and IN 2 BNC connectors.
7. Connect the AES/EBU OUT 1 BNC connector to an AES digital audio
acceptor (for example, a DAT recorder).
8. Optional—Connect a controller via either RS-232 and/or a LAN to the
Ethernet RJ-45 connector.
5.1
Connecting a Serial Controller to the FC-340S
You can connect to the
FC-340S
via an RS-232 connection using, for example, a
PC.
To connect to the FC-340S via RS-232
:
•
Connect the 3-pin terminal block on the rear panel port of the
FC-340S
(pin
G to pin 5, pin Rx to pin 3, pin Tx to pin 2) to the RS 232 9-pin D-sub port on
your PC
5.2
Connecting to the FC-340S via Ethernet
You can connect the
FC-340S
via Ethernet via either of the following methods:
•
A crossover cable (see
Section 5.2.1
) for direct connection to the PC
•
A straight through cable (see
Section 5.2.2
) for connection via a network hub
or network router
After connecting the Ethernet port, you have to install and configure your Ethernet Port. For
detailed instructions, see the Ethernet Configuration Guide (Lantronix) in the technical support
section on our Web site
http://www.kramerelectronics.com
.