INSTALLING THE BOARD:
NOTE: The millivolt board is fitted with a gasket to seal the millivolt board. Make certain this gasket is properly
placed around the opening before installing the regulator board. If the gasket is damaged a replacement one
must be used.
1. Grasp the board with both hands and place into the unit, aligning the (6) mounting holes in the board to the
moutning studs as the bottom of the firebox (Figure 15B).
CAUTION:
Before securing the board into place make sure that all of the wires (attached under the board) are clear and unobstructed.
2. Attach the 1/4" nuts (included with the board assembly) and tighten.
3. Install the burner tube by positioning it over the burner orifice and aligning the mounting holes at the sides of
the burner tube onto the tabs on the millivolt board.
4. Position the log plate over the top of the front burner tube, aligning it between the tabs on the board (Figure
15A).
5. Connect the flexible gas line to the manual shut-off valve.
6. Reconnect any wall switch, remote control or thermostat wires onto the top and bottom terminals on the gas
valve.
7. Replace the logs. (Refer to the diagrams in this manual for proper placement.)
8. Replace the glass assembly and upper grill.
9. Verify proper operation of the fireplace and log position. Refer to the lighting instructions in this manual.
IMPORTANT:
CHECK ALL CONNECTIONS WHETHER FIELD OR FACTORY MADE FOR LEAKS!
Page 24
