9. Push in the black control knob all the way and hold in. Press the SQUARE igniter button (B). The pilot will
generally light with two or three pushes on the igniter. Hold the knob in for about one (1) minute after the pilot
is lit. Release knob and it w ill pop back out. Pilot should remain lit. If it goes out, repeat steps 5 through 9.
*If knob does not pop out when released, stop and
immediately call your service technician or gas supplier.
*If the pilot w ill not stay lit after several tries, turn the gas
control knob to "OFF" and call your service technician or gas
supplier.
10. Turn black control knob (A) counterclockwise to "ON".
11. Flip the ON/OFF switch (C) to the "ON" position. If using a
thermostat, leave on/ off switch ‘OFF’ and set the thermostat
to desired setting.
12. Close the lower grill.
13. Turn on electric power to the fireplace.
NOTE: When the unit is initially lit, condensation w ill appear on the glass, this is normal in all gas fireplaces,
and will disappear in one to three minutes.
14. If you wish to turn the burner off, flip the on/ off switch to the ‘OFF’ position. If a w all switch has been
installed, simply turn it off. I f a thermostat has been installed, simply adjust temperature setting.
NOTE: The pilot w ill stay lit.
TO TURN GAS OFF TO APPLIANCE
1. Open the lower grill by grasping the center of the top louver, then pull out and down to access the gas
control valve.
2. Set the thermostat to the lowest setting. (If installed)
3. Turn off all electric power to the appliance if service is to be performed.
4. Push in control knob(A) slightly and turn clockwise ` to “OFF”. Do not force.
KEEP BURNER & CONTROL COMPARTMENT CLEAN. SEE INSTALLATION AND OPERATING INSTRUCTIONS ACCOMPANYING APPLIANCE.
NOTE: Children and adults should be alerted to the hazards of high surface temperature and should stay away
to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the same
room as the appliance.
Clothing or other flammable material should not be placed on or near the appliance.
INITIAL BURN PERIOD
AN ODOR WILL OCCUR DURING THE FIRST FEW HOURS OF BURNING. THIS IS THE PAINT CURING AND SUBSTANCES
USED IN THE MANUFACTURING PROCESS. IT IS RECOMMENDED TO LEAVE THE FAN (IF INSTALLED) OFF DURING THIS
PERIOD AS IT WILL SPEED UP THE PAINT CURING PROCESS.
DUE TO THE MAKEUP OF THE LOGS & REFRACTORY, THEY WILL DISCOLOR DURING THE INITIAL BURNER PERIOD.
THIS MAY TAKE UP TO 4 HOURS OF BURN TIME. ONCE THE CURING PROCESS IS COMPLETE, THE TRUE COLOR WILL
RETURN.
IMPORTANT:
DO NOT BURN THIS FIREPLACE WITHOUT THE GLASS ENCLOSURE PROPERLY IN PLACE.
**MAKE SURE THE HOMEOWNER IS AWARE OF THIS**
NOTE: THIS FIREPLACE MAY PRODUCE NOISES OF VARYING DEGREE AS IT HEATS AND COOLS TO DUE METAL
EXPANSION AND CONTRACTION. THIS IS NORMAL AND DOES NOT AFFECT THE PERFORMANCE OR
LONGEVITY OF THE FIREPLACE.
Page 20
