Installation Planning
SECTION 3
FRAMING
#SFD-36
R.6 February 2022
11
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
3.0 FRAMING
3.1 Installation Planning
This appliance offers design options for managing the heat produced
by this fireplace.
Read all documentation for your specific installation
and design options prior to appliance installation.
•
Heat Transfer Kit(s)
allows you to transfer heat to a specific area
inside your home (interior) or directly outside (exterior). This
appliance can have (2) heat transfer kits installed at the same
time. It can be up to two of the same heat transfer kits, or a
combination of interior and exterior kits. See the HTK-EXT and/
or HTK-INT manuals for further information.
If you are planning an installation with the use of an exterior
and/or interior kit,
the minimum dimensions listed in this
section will apply for your framing installation.
If you are planning a corner installation with use of an exterior
and/or interior kit, the requirements in section
TRANSFER KIT INSTALLATION REQUIREMENTS
must be followed.
•
If planning to convert to propane, it is easier to complete the gas
conversion before framing in the fireplace. See the #LCK-SF36-D
manual for complete conversion instructions. If you convert the
fireplace to propane after fireplace installation, you will have to
remove the control board. See section
on page 44 for access to the
control board before and after installation.
3.1.1 Appliance Placement Considerations
WARNING: Due to high temperatures, the appliance should be located
out of traffic and away from furniture and draperies.
•
This appliance must be installed on a level surface capable of
supporting the fireplace and venting. Determine your vent
requirements before framing your appliance.
•
This fireplace may be installed in a bedroom.
•
Please be aware of the large amount of heat this fireplace will
produce when determining a location.
