Page 6
2. Replace ash drawer and close and latch ash door.
3. Check hopper capacity, fill if necessary.
4. Set control switch, located at the top of the circuit board, to the ‘PELLETS’ setting.
5. Place 6 oz. wood pellets into the burn pot.
6. Close and latch door.
7. Press the ON/OFF button on the circuit board once. This will illuminate the LED light just above the button, turn
on the electronic ignition probe in the burn pot, and begin the start up program.
The pellets will begin to smoke and will combust into flame in approximately 2 minutes. After 4 ½" minutes, the
auger will turn ‘ON’ and begin feeding wood pellets into the burn pot. The LED light just above the ‘Auger’ button
will light up each time the auger goes on.
NOTE: The electronic ignitor will stay on for approximately 7 minutes, even though flame may have already
been established in the burn pot.
8. Adjust heat setting level to desired position - #1 - #5, with #5 being the highest heat setting. The most preferred
setting is #3.
9. Pivot the control circuit board counter-clockwise down to the concealed position if desired.
50/50 OR UNLIMITED MIXTURE OF CORN / PELLETS
1. Check ash drawer capacity - Grasp the handle located just underneath the shelf and turn clockwise to
unlatched the ash door. The ash drawer is located directly behind the ash door. Slide the drawer out, check
capacity and empty if necessary.
DISPOSAL OF ASHES:
Ashes should be placed in a metal container with a tight fitting lid. The closed
container of ashes should be placed on a noncombustible floor or on the ground, well away from
all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or
otherwise locally dispersed, they should be retained in the closed container until all cinders have
been thoroughly cooled. . Note: Ashes can still be hot after 24 hours under the right conditions.
2. Replace ash drawer and close and latch ash door.
3. Check hopper capacity, fill if necessary.
4. Set control switch, located at the top of the circuit board, to the ‘CORN’ setting. NOTE: At start-up, the ‘Pellets’
setting may be used for a brief period of time. Extended use on the ‘Pellets’ setting will cause the burn pot to
‘flood’.
5. Place 6 oz. corn/wood pellets mixture into the burn pot.
6. Close and latch door.
7. Press the ON/OFF button on the circuit board once. This will illuminate the LED light just above the button, turn
on the electronic ignition probe in the burn pot, and begin the start up program.
The pellets will begin to smoke and will combust into flame in approximately 2 minutes. After 4 ½" minutes, the
auger will turn ‘ON’ and begin feeding wood pellets into the burn pot. The LED light just above the ‘Auger’ button
will light up each time the auger goes on.
NOTE: The electronic ignitor will stay on for approximately 7 minutes, even though flame may have already
been established in the burn pot.
8. Adjust heat setting level to desired position - #1 - #5, with #5 being the highest heat setting. The most preferred
setting is #3.
9. Pivot the control circuit board counter-clockwise down to the concealed position if desired.
