kozy heat MINNETONKA 55345-RF, Installation And Operation Manual

Page: 11 / 67

1. Frame an opening for the fireplace, allowing for vent installation and type of installation (corner, flat wall, clean face application).
2. If masonry (optional) will be used, prepare foundation for the masonry load. A lintel is required to support the added weight above the fire-
place.
3. Attach nailing flanges to fireplace.
4. Insert fireplace into framing.
5. Install the hearth (if applicable).
6. Complete the gas line installation.
7. Complete the electrical hook-up. Install any standard or optional electrical components at this time.
8. Complete the venting installation.
9. Secure fireplace to flooring through holes located in the outer box bottom and to framing with nailing flanges. Verify all clearances at this
point.
10. Install facing material, mantel or cabinetry, allowing room for optional full face doors, if applicable.
11. Install logs.
12. Install grills and optional decorative doors / faces.
13. Verify proper operation of fireplace and all components.
PLACEMENT CLEARANCE REQUIREMENTS
This fireplace must be installed on a level surface capable of supporting the fireplace and venting.
Fireplace must be placed directly on wood or non-combustible surface (not linoleum or carpet) extending the entire depth and width of fire-
place.
Due to high surface temperatures, fireplace should be located out of traffic and away from furniture and draperies.
This fireplace may be installed in a bedroom.
Please be aware of the large amount of heat this fireplace will produce when determining a location.
SPECIFICATIONS
INSTALLATION OVERVIEW
NOTE: The qualified installer should follow the
procedure best suited for the installation.
PAGE 8
MODEL #55345 COMPONENTS LIST
(#MTK-770) - Millivolt Board Assembly with 18” Flexible
Gas Line attached
(#700-203) - Manual Gas Shut-off Valve
(#MTK-135A) - Burner / Log Grate Assembly
(#MTK-G900) - Refractory Set
(#MTK-500A) - Log Package
(#MTK-057T) - Glass Frame Assembly
(#OCK-S5168) - LP Conversion Kit
(#600-083) - Receptacle / Speed Control Assembly with (3)
Wire Nuts
(#942085) - 5” Restrictor Plate
(#500-MTK) - Grill Assembly: Upper Hood, Upper Louver,
Lower Grill
MODEL #55345-RF COMPONENTS LIST
(#MTK-800-RF) - Millivolt Board Assembly with 18” Flexible
Gas Line attached
(#700-203) - Manual Gas Shut-off Valve
(#MTK-135A) - Burner / Log Grate Assembly
(#MTK-G900) - Refractory Set
(#MTK-G900) - Refractory Set
(#MTK-500A) - Log Package
(#PRC-028-RF) - RF Fan Kit
(#MTK-057T) - Glass Frame Assembly
(#OCK-H5168L-RF) - LP Conversion Kit
(#700-108) - Remote control
(#942085) - 5” Restrictor Plate
(#500-MTK) - Grill Assembly: Upper Hood, Upper Louver,
Lower Grill