kozy heat Jackson XL, Installation And Operation Manual

Page: 21 / 37

INSIDE FIT APPLICATIONS:
NOTE: INSIDE FIT APPLICATIONS REQUIRE THE „INSIDE FIT MOUNTING BRACKETS‟, INCLUDED WITH THE SHROUD,
FOR INSTALLATION.
1. Remove the glass assembly. Refer to page 8 if necessary.
2. Assemble the shroud, install the upper grill & on/off rocker
switch as described on page 17-18 of these instructions.
3. Referring to Figure H-4, use a tin snips to cut off the lower end
of all (4) mounting tabs on the shroud side pieces.
IMPORTANT- MOUNTING BRACKET ORIENTATION:
The bracket with the notched out section at the bottom is the
right mounting bracket. Figure H-5.
The flanges on both mounting brackets shroud should be
toward the inside of the fireplace. Figure H-5.
4. MASONRY PANEL INSTALLATIONS: If you have installed the
optional masonry panels, refer to Figure H-6A below.
Remove the screws (A) (2 ea. side) securing the masonry panels.
Figure H-6A.
Cut lower end of
each tab at the
location shown.
Figure H-4
Note flange orientation
5. Align the holes in the right mounting bracket to the corresponding holes in the fireplace face & masonry panels. Figure H-6A.
NOTE: Make sure the brackets are positioned as shown in figure H-5.
6. Secure the bracket to the face through the top & bottom holes with (2) of the screws provided (A) and the center holes (2) with
the screws (B) removed in step #4. Figure H-6A.
7. Repeat for left mounting bracket.
8. Position the tabs (lower end previously cut), on the shroud, 2 each side, into the slots in the fireplace face and align the oblong
holes on the left & right inside flange of the side shroud pieces to the holes in the mounting brackets.
Secure with the remaining (4) screws (C), 2 each side. Figure H-6B.
Figure H-6A Figure H-6B
Secure brackets at top & bottom holes with screws provided. Secure shroud to brackets at inside flange
A
C
B
PAGE 17
Figure H-5