PRECAUTIONS OF SAFETY
○
Before the installation, operation, maintenance and inspection, read carefully this
instruction manual and other accompanying documents for correct service.
Familiarize with the knowledge of equipment, information of safety and all of cautionary
instructions for service.
The precautions of safety are shown in each equipment of the centralized lubricating
system by using safety mark.
Particular attention should be called to the places where these safety marks are given.
The safety marks are classified into "WARNING" and "CAUTION", but there are other
equivalent displays.
Please be sure to follow as they contain important contents.
If mishandled; a dangerous situation may
occur, it could result in death or serious
injury.
If mishandled; a middle injury or light injury
and a physical damage may occur.
For the matter being mentioned in the CAUTION, it may result in an importance
according to situation. The important content is given to all of safety mark, and obey it
without fail.
The Maximum Working Pressure of this equipment is 3MPa (30kg/cm
2
).
In case to disassemble and inspect each equipment, stop the operation of pump, and
release the pressure to decrease the operation as 0MPa (0kg/cm
2
).
If the pressure is increased under the condition in which air is in the pipe, the air in the
pipe is compressed.
When releasing the pressure or removing the piping, if you face or your body face in the
direction which the air will escape, the grease in the piping may blow out, which is
dangerous. Do not point your face or body in the direction which the air blows out as it may
cause an accident or injury.