Koso REXA Electraulic Xpac, Installation And Operation Manual

Page: 39 / 164

REXA
Electraulic Actuators & Drives
Xpac
Installation Manual -- Version 5.1 (5/08)
31
6.3 SEtUP Mode
In the
SEtUP
mode, the actuator is under the control of the three
button keypad. The actuator is off-line and does not respond to the
control signal. The
SEtUP
mode provides the means to tune the
actuator for your specific application. For convenience, the
SEtUP
mode is divided into several groups of parameters. Each group is
identified by a sub-menu heading. Sub-menus are selected by press-
ing the (E)NTER key. Once the desired sub-menu is displayed, the
sub-menu is traversed by pressing the Scroll Down key. The first
parameter of the sub-menu will be displayed. Subsequent use of the
Scroll Down key, displays the next succeeding parameter until the
end of the sub-menu is reached. The Scroll Up key does the reverse,
redisplaying the previous parameter until the sub-menu heading is
reached, at which point a new sub-menu may be selected. A flow
chart for the
SEtUP
mode is as follows:
A parameter that is on display may be changed by pressing the
(E)NTER key. The parameter code will blink. Most values are
changed by the use of the Scroll Up and Scroll Down keys. When
the desired value is reached, press the (E)NTER key. The parameter
code will stop blinking and the displayed value will be saved as the
new value. Certain parameters are checked for validity when a new
value is entered. If the new value is not valid when entered, the PCP
will briefly display "error", then revert to the parameter display with
the old value.