Korenix JetNet 4000, User Manual

Page: 43 / 49

Web-based Management
Korenix JetNet Series Industrial Web-Managed Ethernet Rail Switch User’s Manual 3-27
Save Configuration
Save Configuration allows you to save any configuration you just made to the flash memory.
Powering off the JetNets without clicking on Save Configuration will cause the new settings to be
erased. Click on
Save Flash to save your new configuration.
Rate Control
In this section, you can configure each port’s bandwidth rage and packet limitation type.
Limit packet type : you can select the packet type that you want it to be filtered. The packet
types listed here include broadcast/multicast/unknown Unicast packet, broadcast/multicast
packet, and broadcast packet only. The broadcast/multicast/unknown Unicast packet,
broadcast/multicast packet, and broadcast packet only are only for ingress packet. The egress
rate only supports all type packet.
Bandwidth : Port 1 to Port 8 support port ingress and egress rate control. For example, let’s
assume port 1 is 10 Mbps, you can set its effective egress rate to be 1 Mbps, and ingress rate to
be 500 Kbps. The JetNet uses the packet counter to control the number of packets coming in so
that the configured ingress rate can be achieved.
Ingress: here you can select the port effective ingress rate. The valid values are 1MB, 2MB, 4MB,
8MB, 16MB, 32MB and 64MB. The default value is “disable”.
Egress: here you can select the port effective ingress rate. The valid values are 128kbps,
256Kbps, 512Kbps, 1MB, 2MB, 4MB, and 8MB. The default value is “disable”.
Click on Apply to apply the configuration.