Korenix JetNet 4000, User Manual

Page: 18 / 49

Korenix JetNet 4000 Series Industrial Web-Managed Ethernet Rail Switch User’s Manual 3-2
Introduction
An embedded HTML website is placed in the flash memory inside the CPU board of the JetNet.
This HTML website allows users to use a web-based management interface to configure JetNets
from anywhere on the network via a standard browser, such as Microsoft Internet Explorer or
Mozila.
The web-based management interface supports Internet Explorer 5.0 and Mozila 1.7.5(including
Fire Fox version). It is based on Java Applets with aiming to reduce network bandwidth
consumption, to enhance the access speed, and to offer an easy-to-use management screen.
Note : IE 5.0 or any later version does not allow Java Applets to open sockets by default. Users
have to directly modify the browser settings to enable Java Applets to use network ports.
Preparation for Web Management
Before you start to use Web-based management interface to manage JetNets, make sure that
JetNets are properly installed on your network, and every PC on this network can check JetNets
via the web browser. Here we use JetNet 4008f as an example.
1. Make sure your network card is working normally, and your operating system supports
TCP/IP protocol.
2. Wire the JetNet’s DC power input and connect your computer to the JetNet.
3. Make sure that the JetNet’s default IP address is 192.168.10.1.
4. Change your computer’s IP address to 192.168.10.2.
5. Switch to DOS command mode, and ping 192.168.10.1 to make sure that the respond time
is normal.
System Login
1. Launch the Internet Explorer on the PC.
2. Type http:// and the IP address of the JetNet. And then press Enter .
3. The login screen will appear next.
4. Key in the user name and the password. The default user name and the password is admin .