7/27
F i l t e r C o n t r o l F S - 2 1
FS-21.doc | Status 2015 - 02 - 09
3.1.1
The LED – Indicators
LED (green)
Lights up when the device is switched on
and power is supplied.
LED (green / yellow)
Lights up continuously green when the filter is in operation.
Flashes green at 2s cycles when the filter is ready in standby
Flashes green in a 1 second cycle during regeneration, when
step setting mode is accomplished.
Is off when the filter is switched off.
Lights up continuously yellow when filter is in regeneration.
LED (yellow)
Lights up continuously when the filter is in HAND mode.
Is off when the filter control is in AUTO mode.
LED (red)
Flashes at 1 s intervals when a fault has occurred.
Lights up continuously when a fault is acknowledged
but the cause not yet located.
3.2
The LCD – Display
The LC display serves to display operating states (operating mode) and the
parameters (configuration mode).
3.2.1
One Filter Operating Mode
3.2.2
Two Filter Operating
Mode
More display variations are can be set up in two-filter mode and are explained in more detail
in Chapter 4.
E.g.:
Display of the operating status in two-filter mode. Lines 1 and 2 display the states for
Filter 1, Lines 3 and 4 display the states for Filter 2.
3.2.3 Parameter
Mode
In Parameter mode, Line 1 displays the parameter menu option and Line 2 – 4 the
parameters and values which can be changed.
3
LED
Filter 1 operating
Capacity: 10.0 m3
Consumption: 8.0 m3
remaining: 2.0 m3
Filter1 Cap: 10.0 m3
Consump.: 8.3 m3
Filter2 Cap: 10.0 m3
Consump.: 5.4 m3
Type of Device:
one Filter
