Error handling while programming
·
No signal appears:
-
The Tx is not turned on.
-
The receiver battery is not connected.
-
The speed control is not connected to the Rx or pocketed
wrong.
-
The jumper was not affixed and/or not removed again.
·
Signals, then steady burning light or nothing:
-
The throttle position „back" (brake and/or motor off position) is
too dense to the throttle position „front" (full speed position).
-
The distance between the throttle position „back" (brake and/or
motor off position) and throttle position „front" (full speed
position) is too large. This error can only occur with a computer
Tx.
Correction
: Program throttle control to +/-100%, if necessary
lower.
-
The speed control is pocketed in a wrong receiver socket.
-
Large shift of the throttle positions to long pulses (one of the
throttle positions must have a pulse length less than 2 msec.).
This mistake can only occur with computer Tx.
Correction
: Set no shift to the throttle control (offset) at the Tx.
