Connection of the cables
Motor cable
(red - green - blue)
The sequence is arbitrary. The motor rotation will be reversed by
changing 2 motor cables (see also mode programming).
This speed control needs no sensor information. If there is a sensor
cable out of the motor, it will not be used.
Use only polarized connectors for the battery cables!
Connecting the battery with reverse polarity will destroy the speed
control. It contains a polarity sensor, so incorrect polarity can easily
be discovered.
Setting up the speed control to your equipment:
The speed control comes with an APM (Auto-Programming-
Mode), so it will equalize itself to the throttle position of the RC.
Proceed as follows:
a) Switch on the RC.
b) Set the throttle control to off.
c) Connect the battery to the Smile.
d) Give 1 sec. full throttle or start with full throttle.
e) Ready.
f) If the motor fails to start, disconnect the battery and change
over the throttle servo reverse switch in the Tx.
g) Start again from a) above
It’s necessary to read the security information in the operation
manual