KONTRON
CMP/P3 and CMP/C3 User’s Guide
5
Getting Started
3.
GETTING STARTED
The easiest way to get the coolMONSTER/P3 or coolMONSTER/C3 board running is to use a PISA
baseboard from Kontron Embedded Modules GmbH. Take the following steps:
1.
Turn off the power supply.
2.
Connect the power supply to the baseboard or the coolMONSTER.
3.
Plug a memory module into the memory socket of the coolMONSTER.
4.
Plug the coolMONSTER to the PISA baseboard.
5.
Connect the CRT monitor to the CRT interface or a LCD panel to the JILI interface by
using the corresponding adapter cable.
6.
Plug the keyboard to the PS/2 keyboard connector and the mouse to the PS/2
mouse connector.
7.
Connect the floppy drive cable to the coolMONSTER floppy interface. Attach the
floppy drive to the connector at the opposite end of the cable.
8.
Connect the power supply to the floppy’s power connector.
9.
Plug a hard-drive data cable to one of the coolMONSTER hard-disk interfaces.
Attach the hard disk to the connector at the opposite end of the cable.
10.
If necessary, connect the power supply to the hard disk’s power connector.
11.
Make sure all your connections have been made correctly.
12.
Turn on power.
13.
Enter the BIOS by pressing the F2 key during boot-up. Make all changes in the BIOS
setup. See the BIOS chapter of this manual for details.
