10. Motion Detection Setup
Set the environmental parameters for
Motion
Detection
(MD) trigger events, including the first
group (red) and the second group (green). You may
change the following settings in the enabled mode:
Reset MD range: Select
motion_detec
1
, click and
hold your mouse (in this case the upper left corner of
the MD range is displayed), drag your mouse to select
a range, and release your mouse.
Cancel MD: Same as above, but you only need to
click and hold your mouse, and then release it to
cancel MD.
Motion_detec_set: Set MD sensitivity. The default
value is 15. That is, the MD will start in the event of a
15% change in the MD range. The lower the value,
the higher the sensitivity will be.
Upon MD startup, the prompt "Motion_Detec
Warning!!" will appear in the upper left corner of the
window due to the MD change of MD1 or MD2, as
shown in the following figure:
Note:
1. If the image resolution is 640x480 / 320x240, you
may select a framed trigger range at will.
2. If the image resolution is 160x120, the trigger range
is the entire image (fixed).
