Konig & Meyer 24730-000-55, Translation Of The Original Operating Instructions

Page: 25 / 29

Troubleshooting
Fault list
Maintenance
General
u
Regularly remove dust and dirt from the stand.
u
Regularly check the stand for damage.
u
Replace worn end caps as necessary.
If further defects should occur, please send the stand to the manufacturer for repair.
Spare parts
Disposal
Disposal of the stand including all attachments is subject to the local disposal regulations and the
environmental protection laws in the country of use.
Fault Remedy
Stand wobbles Extend legs to a maximum and tighten the
clamping screws.
Stand tube wobbles or moves under load Check whether the release button is pressed.
Tighten the clamping screws.
Height adjustment sluggish Check whether the clamping screw of the
corresponding crankcase is loose.
Height adjustment does not work despite
crank movement Check whether the hand crank is fully
inserted
Hand crank can be pulled off without
pressing the push button Insert the hand crank completely.
The stand cannot be cranked down Check whether the clamping screw of the cor-
responding crankcase is loose.
Keep the release button permanently pressed
whilst cranking.
Naming Order no.
Clamping screw M8 x 16 mm 01-82-763-55
Clamping screw M8 x 21 mm 01-82-783-55
End cap 01-84-942-55
Hand crank »Speedlock« 6-24740-1-55
Hexagon screw M10 x 40 mm 03-01-760-25
Washer 01-36-320-55
25