Lifting the load
✓
The stand is securely set up.
✓
The hand crank is inserted in the upper crankcase
✓
Both stand tubes are in the lower end position.
✓
The clamping screws are tightened.
✓
If the load is within the range of movement of the crank, the extension tube must be free by
✓
approx. 100 mm before placing the load.
1
Place the load.
2
Loosen the clamping screw of the crankcase.
3
Turn the hand crank clockwise until the desired
3
height is reached.
4
Tighten the clamping screw of the crankcase.
5
Switch the hand crank onto the lower crank-
5
case
6
Repeat steps 2 to 4 with the lower crankcase.
7
To prevent access by unauthorised persons,
7
remove the crank handle, if necessary.
23
Mount and dismount hand crank
1
Keep the push button on the hand crank
1
pressed.
2
Mount the hand crank completely onto the
2
drive shaft.
3
Release the push button.
3
➲
Now the hand crank is firmly connected to
3
➲
the drive shaft and can be used.
To dismount the hand crank, keep the push button
pressed and pull it off.
