E-7
(24) Remove the control panel cable from the edge
cover and the wire saddle.
(25) Remove the control panel cable from the edge
cover and 10 wire saddles.
(26) Open the upper rear right door and disconnect
the panel connector.
(27) Remove the control panel cable from the three
edge covers, then pull out the cable.
(28)
<When installing the Local Interface Kit EK-611>
a) Refer to the installation manual for the Local
Interface Kit EK-611 to install the Local Inter-
face Kit EK-611.
Note:
• Connect the supplied cable to the connector
shown in the illustration. For how to connect the
cable to the control panel, refer to the following
procedures of this manual.
• Connect the white connector to the local inter-
face board unit.
b) Route the supplied cable as shown in the illus-
tration.
Wire saddle
Edge cover
Wire saddle
Edge cover
Edge cover
