Kongskilde CM 305 F, Operator'S Manual, Page: 43 / 58

4. GREASING
PIGB 097A 05 CM 305F 0218
43
4. GREASING
GREASE
Always make sure that the machine has been properly and sufficiently greased
before working.
Go through the greasing chart on the opposite page.
Type of grease: Universal grease of good quality.
The rotor gearbox is pre-lubricated with special grease type:
SHELL ALVANIA EP 0 LF
Check and refill is not necessary.
When repairing only use this type of grease. Fill
up to the lower side of the main shaft.
Rotating mechanical connections are greased with grease or oil as required.
IMPORTANT - REMEMBER:
Lubricate the PTO shaft after every 10 working
hours. Pay special attention to the sliding profile tubes of the PTO
shaft.
They must be able to slide back and forth when the torque is heavy
during work.
If you neglect to lubricate the profile tubes sufficiently, it will
result in high frictional forces
(seizing) which will damage the
profile tubes and in time also connecting shafts and bearings.