Kongskilde CM 305 F, Operator'S Manual, Page: 27 / 58

2. CONNECTION OR DISCONNECTION AND TEST DRIVING
PIGB 097A 05 CM 305F 0218
27
2) When starting, the machine should be in working position.
3) A sudden increase in the number of revolutions of the machine, e.g. when driving
into the field or after turning in the field, should also take place with the machine
close to working position.
4) Listen to the number of revolutions of the tractor when working in the field. If the
number of RPM falls slowly or is suddenly reduced it may be a sign of overload of
the transmission due to too high driving speed or foreign matter in the cutting unit.
In this case, disconnect the PTO immediately and let the
machine “rest”.
TRANSPORT SAFETY
The machine has a built-in mechanical transport safety device. When the machine is
connected and lifted with the tractor hydraulics, it must be secured before transport.
Fig. 2.11 Activate the locking pawl D before transporting the machine.
IMPORTANT:
The lock must always be in the position shown on the figure during
transport of the machine.
P
R
1
1
-1
6
2
8
D
Fig. 2.11