Kongskilde CM 305 F, Operator'S Manual, Page: 15 / 58

1. INTRODUCTION
PIGB 097A 05 CM 305F 0218
15
In case the machine is connected to the tractor during repair and maintenance you
should make sure that:
The PTO is disconnected
The tractor engine is stopped
The ignition key is removed and
When the machine is raised, the link arms must always be secured by support
chains.
Be careful when using high pressure cleaners, particularly near bearings and seals.
MACHINE SAFETY
All revolving parts are balanced by KONGSKILDE by means of a special machine
with electronic sensors. If it turns out that a part still has an unbalance, small
counterweights should be mounted.
As the rotor skirts run at up to 2000 RPM, even the slightest unbalance will cause
vibrations which may lead to fatigue fractures.
When replacing blades, all blades on the rotor in question must be replaced as not to
create an unbalance.
During the season check daily that no blades, carriers or bolts are missing. If any of
these are missing, mount new parts immediately.
Clean the space between rotor skirt and guide shoe of earth and grass regularly.