Koncar SE 5013 P.BH0, Operating And Installation Instructions

Page: 74 / 75

EN
74
power supply is also possible, subject to restrictions in respect of simultaneous operation of all
power consuming components of the cooker (heating plates or zones and the oven).
Connection cable is not supplied with this cookers.
For the connection of the cooker to the power supply use insulated cable type H05RR– F with
a protective yellow-green sheath, approx. 1,5 m long.
Connect the cooker to a properly installed and earthed wall socket with its own circuit and 16 A
fuse. The wall socket shall be easily accessible (to comply with pole isolation legal
requirements) and shall not be exposed to heat radiation. This means that the socket shall not
be located immediately behind the cooker and the connection cable shall not come in contact
with the rear wall of the cooker.
The electrical connection shall be a permanent direct connection (not plug-and-socket type),
furnished with pole isolation switch, in compliance with applicable national legislation.
CONNECTING PROCEDURE:
To connect the cooker, it is NOT NECESSARY to remove the rear panel of the cooker.
With a screw driver, release the connection box cover to get access to the connection
terminals.
MAKE SURE that the connection cable is inserted through an appropriate support, which is
an integral part of the connection box and keeps the cable in place.
Connect the cable to the terminals as shown in the Figures 11, 12 or 13, taking into
account that, subject to the connection method, bridges should be installed.
Tighten the cable support and close tightly the connection box cover.
ATTENTION !
The cooker shall be earthed !
The manufacturer assumes no liability for injuries and/or damages
caused by non-compliance with of this requirement. Electrical safety
of the cooker is granted only provided that it is correctly connected to
a properly earthed power supply system.
Oven light bulb replacement
Prior to proceeding with the replacement, make sure that power
supply is disconnected.
To replace a burnt bulb unscrew the protective glass cover, install a new bulb and replace the
protective glass cover.
Burnt bulb should be replaced by a new one. Use always the bulbs with E14 neck, 230V, 25W,
T300
°
C.
Note:
The manufacturer retains the right to modify the design, dimensions and
weight of the product if it deems necessary to improve the product
quality and assumes the responsibility for spare parts supply and repair
services over a period of 7 years from the date of purchase.