EN -25-
•
Do not place glass bottles or beverage cans in the ice-making
compartment as they can burst as the contents freeze.
• Do not place explosive or flammable material in your freezer. Place
drinks with high alcohol content vertically in the freezer and make sure
that their tops are tightly closed.
•
When removing ice from the ice-making compartment, do not touch it. Ice may
cause frost burns and/or cuts.
•
Do not touch frozen goods with wet hands. Do not eat ice-cream or ice cubes immediately
after you have taken them out of the ice-making compartment.
•
Do not re-freeze frozen goods after they have melted. This may cause health issues such
as food poisoning.
•
Do not cover the body or top of freezer with lace. This affects the performance of your
freezer.
•
Secure any accessories in the freezer during transportation to prevent damage to the
accessories.
•
Do not use plug adapter.
Installing and operating your freezer
Before starting to use your freezer, you should pay attention to the following points:
•
The operating voltage for your freezer is 220-240 V at 50Hz.
•
We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your freezer where it will not be exposed to direct sunlight.
•
Your appliance should be at least 50 cm away from stoves, gas ovens and heater cores,
and at least 5 cm away from electrical ovens.
• Your freezer should never be used outdoors or exposed to rain.
• When your freezer is placed next to a deep freezer, there should be at least
2 cm between them to prevent humidity forming on the outer surface.
•
Do not place heavy items on the appliance.
•
Do not place anything on your freezer, and install your freezer in a suitable
place so that at least 15 cm of free space is available above it.
•
Use the adjustable front legs to make sure your appliance is level and
stable. You can adjust the legs by turning them in either direction. This should be done
before placing food in the freezer.
•
Before using your freezer, wipe all parts with a solution of warm water
and a teaspoon of sodium bicarbonate, then rinse with clean water and
dry. Place all parts in the freezer after cleaning.
•
Install the plastic distance guide (the part with black vanes at the rear)
by turning it 90° (as shown in the figure) to prevent the condenser from
touching the wall.
•
The freezer should be placed against a wall with a free space not
exceeding 75 mm.
Summary of Contents for L1A 60 325.BVN
Page 55: ......
