11
3 PCB settings
3-1 PCB start-up check (self test)
When this kit has been set up, turn ON the machine’s power switch. The game Printed Circuit
Boards (PCB) will be automatically checked for its performance. The test results will be displayed
on the screen.
•Before use, be sure to check the performance of the kit (PCB).
•If an abnormality persists or the machine does not operate properly, immediately turn
OFF the machine’s power switch, unplug the power cord from the receptacle and
contact your nearest dealer.
Result of test
•The machine goes to the game mode and the demonstration game gets started.
If test is OK
If any abnormality is detected
• “BAD” appears on the screen, and the checking is repeated.
If "25C MBAD" appears, turn OFF the power switch, hold down the machine's test switch,
and turn ON the power switch again. Keep the test switch down until "TEST SWITCH IS
STILL ON PLEASE RELEASE IT" appears on the screen. (The settings in the manual test
mode will be back to the factory ones.)
When the machine has been installed or any of the PCBs has been repaired or replaced, hold
down the machine's test switch and turn ON the power switch. The settings will be back to
the factory ones. If any indication other than above shows up or the machine does not work,
immediately turn OFF the machine’s power switch, unplug the power cord from the recep-
tacle and contact your nearest dealer.
Summary of Contents for Nagano Winter Olympics '98
